floor pan
Moderator: FORDification
-
- New Member
- Posts: 6
- Joined: Mon Aug 15, 2011 2:07 am
floor pan
on my 68 f100 i am needing to replace the floor pans on both sides. the passenger side is not bad at all, but the driver side extends to the rear of the cab past where regular floor pans cover. does anybody know where i can get a replacement panel for this or am i going to have to fab something up?
- CNM67
- Preferred User
- Posts: 462
- Joined: Sun May 15, 2011 1:57 pm
- Location: Santa Clarita, CA
-
- 100% FORDified!
- Posts: 22329
- Joined: Sun Aug 28, 2005 8:17 pm
- Location: Kansas, Ottawa
- Contact:
Re: floor pan
you'll have to get soemone to cut up a cab to get anymore than the regular floor pan.
- undertakerman
- New Member
- Posts: 77
- Joined: Wed Nov 17, 2010 1:42 pm
- Location: Powder Springs, Georgia
Re: floor pan
Earlier this year I had to replace both my floor pans in my 68 F100. If you are talking just about the short pan then LMC and a couple more have what you need. But if you are talking about the upper floor pan that is under the seat that runs from the back edge of the short pan to the back of the cab and is the full width of the inside of the cab under the seat. I agree with Fordman you will have to go to a junkyard and have some one cut one out for you. You can only buy reproduction full size floor pans up to 1960 that cover that area from what I was able to find out when I was getting ready to replace my floor pans. Good luck with your truck.




You know man can live alone, but he cannot live without Peanut Butter and Grape Jelly.
- basketcase0302
- 100% FORDified!
- Posts: 6805
- Joined: Thu Jan 26, 2006 7:11 am
- Location: Hawthorne, Florida
Re: floor pan
I'd give these guys a call, they list a "rear cab floor section" here:
http://www.rustrepair.com/repair_panels ... sm-ford.pu
http://www.rustrepair.com/repair_panels ... sm-ford.pu
Jeff
http://www.fordification.com/forum/view ... 22&t=46251
SOLD-71 F-350 dually flatbed, 302 / .030 over V-8 with a "baby"C-6, B & M truckshifter, Dana70/4.11 ratio, intermittent wipers, tilt steering, full LED lighting on the flat bed, and no stereo yet (this way I can hear the rattles to diagnose)! SOLD!
Many Ford bumps / one 76' EB / and several dents through the years.
A lot of "oddball" Ford parts collected from working on them for 34 years now!
2008 Ford Escape 4 x 4
http://www.fordification.com/forum/view ... 22&t=46251
SOLD-71 F-350 dually flatbed, 302 / .030 over V-8 with a "baby"C-6, B & M truckshifter, Dana70/4.11 ratio, intermittent wipers, tilt steering, full LED lighting on the flat bed, and no stereo yet (this way I can hear the rattles to diagnose)! SOLD!
Many Ford bumps / one 76' EB / and several dents through the years.
A lot of "oddball" Ford parts collected from working on them for 34 years now!
2008 Ford Escape 4 x 4