Back window channel

[67MercM100]

Does anyone have a picture of the screw that goes in through the door and secures the back window channel?

I just discoverd that both mine are gone. I've got some replacements in, but they're not right; I had to use washers because my screw heads were too small.

[71PA_Highboy]

I have to admit I have no idea what you are talking about. The window channel in the door? AFAIK there is not screw anywhere near the rear window.

If I look at the doors I pulled yesterday, there are no screws in the back of the door.

Hence my confusion. Where are these screws and do you have a pic of the hole that isn't filled properly?

good luck!

[BobbyFord]

This page may have what you need...> http://www.fordification.com/tech/doors01.htm

[67 428 F250]

Can anyone tell me why this picture is not sharp?
Will

[67MercM100]

Yes, I'm talking about the rear channel for the side windows. Let's see if this helps.
The "doors" page really didn't show anything.



PS: How do you attach an image directly? I went through Photobucket.

[67MercM100]

Ah-HA..."Upload Attachment". (Duh!) I missed that before.

[71PA_Highboy]

it is just a standard 1/4-20 bolt with washer on all 6 of the doors I have here... Think window regulator bolts...

These are 68-71 doors... dunno about 67... sorry.

[67MercM100]

Well, a #12 screw seemed to do the job too.
I was just hoping to get it "right". The screws and washers seem to hold things tight OK.