66 fastback project

[Spraygun]

Couple years back i spun my 66 fastback into a bank. I was going t5o take it to work and repair, but there was old work and rust so I decided to chop the rear half off and start over.




I wanted to get more tire under it so I did a mini tub



I used reproduction parts and it was a challenge, luckily I was able to get one pc. frame rails and full quarters, the truck pans were really bad, it took hours to fit them to car.








I built a 347 engine for it:





I did all the bodywork and beefed up the structure, new torqueboxes front and rear, subframe connectors,etc.





A friend bought it before I finished it .

[hazelnut]

A friend bought it before I finished it .
Spraygun

If i put that much work into it to get it fixed and back together again i just dont know if i could have sold it, Must have been a good friend. LOL

[CrypticRacer13]

Red X's is all i see an its killing me inside.............i wannaaaa see tooooooo

[hivewax]

Nice work. That looks familiar.

[Spraygun]

He is a good friend, the best! I've been doing this work for 30 years, i don't get too sentimental about them
The only one I miss is the 64 Vette

[crazyhorse]

Nice vette but I like that mustang, matter of fact I like all mustangs,
some a lot better than others.