new roll pan

Lowered IQ · Post by **Lowered IQ** » Fri Aug 05, 2011 5:03 pm

Does anybody have any experience with a good quality roll pan? Which brand is good? I am looking to add one to my 70.

67mann · Post by **67mann** » Sat Aug 06, 2011 7:36 am

Lot of people make there own Wes...I'm happy with mine......bought from a member but, came from http://www.blueovaltruckparts.com/s-87- ... ?PageNum=0
http://i267.photobucket.com/albums/ii30 ... 19-1-2.jpg
no Xperiance with others

Lowered IQ · Post by **Lowered IQ** » Sat Aug 06, 2011 3:45 pm

Thanks Jerry. That looks about the same as the other ones i`ve seen. We still need to meet up one of these days.

67mann · Post by **67mann** » Sun Aug 07, 2011 10:33 am

I was out your way a little while back when I bought my backhoe,but whenever....those rims will be here

marvin2 · Post by **marvin2** » Wed Aug 10, 2011 9:12 pm

I know that Mar-K makes them as well...I am not sure how any of the different brands stack up quality wise though.

http://www.mar-k.com/index.html

Post by **FORDification** » Wed Aug 10, 2011 9:49 pm

I made my own, using a chunk of bumpside bedside. It was actually pretty easy, and looks darned good. Check out this link:

http://www.fordification.com/myprojects ... op_p13.htm

ezernut9mm · Post by **ezernut9mm** » Wed Aug 10, 2011 11:25 pm

i bought a mar-k for my 93 and it was a quality piece for about 125$ back then. if you don't want to make one, they are the place to go in my book.

Lowered IQ · Post by **Lowered IQ** » Thu Aug 11, 2011 8:18 pm

Thanks, guys. I will have to buy one. Those look to be fine pieces and best of all,my favorite stuff to buy, MADE in the USA. Finding a good used piece of bedside around here that someone would part with is pretty rare. Not only that I need a license plate box on the rear.

The FORDification.com Forums

new roll pan

new roll pan

Re: new roll pan

Re: new roll pan

Re: new roll pan

Re: new roll pan

Re: new roll pan

Re: new roll pan

Re: new roll pan